Recovering, cleaning, and re-using brass cartridges cases is commonly done across the shooting world. After shooting, the brass might case residue ... Read More
These brass parts needed to be tumbled after machining to remove the burrs and discoloration on the surface. The challenge is removing the burrs on the slots without rolling them into the slot and making sure that the surface finish meets the specification. Read More
Dirty Cartridge Brass Casings In the last post we discussed the differences in performance between vibratory tumbling and barrel tumbling to ... Read More
Dirty Cartridge Brass Cleaning cartridge brass (see ‘dirty’ brass above) has traditionally been accomplished using a vibratory or barrel tumbler with ... Read More
A question about deburring, cleaning and polishing brass, copper and aluminum parts. It’s worth reading through the entire question as it ... Read More
Service companies that repair used equipment need to clean various parts prior to re-assembling the equipment. These brass parts (before and ... Read More
Firearm ammunition reloading is becoming a much more popular pursuit for passionate shooters. This process requires cleaning and polishing the spend ... Read More
When a project needs finishing, start here. The last stop for all your surface finishing needs.