Removing the flash off various types of molded parts (see last post) can be done in a wet or try process. Vibratory tumbling with a Plastic or Ceramic media in a wet process can be a quick and easy method to achieve the desired results. After the deflashing step, the parts will generally need to be rinsed and dried.
A traditional dry tumbling process involves the use of Hardwood media that have been treated with an appropriate cream compound. The selection of this compound depends on the needed aggressiveness and required surface finish. The challenge with these compounds isthat sometimes the cream can transfer from the media and become deposited in holes, slots or corners of the part. This then requires cleaning prior to further processing of the part.
An alternative to using creams is a similar previously described process for dry tumbling of wood parts. Depending on the type of part and the amount of flashing that needs to be removed, simply tumbling the parts with Hardwood media and an abrasive grit such as White Aluminum Oxide will provide excellent results with only a light dust on the parts. Because the abrasive material is not ‘attached’ to the media, a barrel tumbler is typically a much better process than vibratory tumbling.